How to Use Railroad Cross Ties for Driveway Borders
- 1). Dig a trench along both sides of your driveway. Make the trench as deep as the railroad ties height as it lays flat on the ground. Normally this is about a foot deep.
- 2). Drill three holes through each of the railroad ties that you place in the trench using a high-powered drill with a half inch spade bit. Drill two holes near the ends and one in the center of each cross tie. Mark where the drill holes are on the side of the ties.
- 3). Place the railroad ties into the trench in a straight line with all the ties flush together at the ends. Pack the area around the ties tightly with dirt.
- 4). Stack another row of railroad cross ties on top of the first row. Ensure that you place them on top so that they overlap the seam of the connecting cross ties underneath. Place the top row of ties flush against each other as with the first row.
- 5). Drill holes through the top row of ties that line up with the holes of the first row. Place steel re-bar into the holes and stake them into the ground with a sledgehammer. This will keep the ties from shifting around.
Source...